Digital battery

Sony Battery is a “consumable”, the degree of damage depends on the Sony VGP-BPS8 Sony VGP-BPS8A battery when you use the battery to the correctness of the operation, the mode of operation, the operating frequency, the temperature of the working environment, time storage (for batteries not used), etc. Factor.

 

1. The battery charge and discharge rate is directly related to battery life, in general, the number of battery charge and discharge lithium of about only 400 ~ 600 times, an improved product, but no 800 times, each time the battery on the end use of a step forward. (When the power of 85% or less of the battery will be recorded and increase the number of times on a single charge.)

 

To this end, when the battery voltage exceeds the battery management process highlighted departure 96% charge, and your current place where there is 220V AC, they should make full use of alternating current to minimize number of recharging the battery to extend the life of the battery.

 

At this stage the battery is not necessary to remove the device because it will not start more than 96% of electricity to recharge the battery. But even so, if you use a long-term supply and rarely used the battery, it is recommended, or remove the battery from the machine to compare well, because the long duration of heat generated when the mobile RN873 GW240 battery will cause some damage. It should be noted that in such cases, once the AC-powered power outages, you have not saved data will facilitate the absence of cell loss, it was a failure, the user must carefully weigh.

 

2. When power is 3 ~ 5%, it must be current to charge the battery or the battery self-discharge phenomenon causes an excessive discharge and damage to the battery, loading the machine and may be arrested suspend any other state, may also be used during charging while.

 

Pricing must be complete, otherwise it will damage the battery. This is based on the reduced sufficiently to avoid an increase in the number of cycles of charge cycles and shorten battery life, rather than due to “memory function” issue, lithium batteries, unlike nickel -cadmium batteries and nickel-hydride batteries have metal “memory characteristics, lithium batteries have no memory” characteristics. ”

 

If the loading machine shutdown or hibernation, when the load to 3 ~ 4 hours after the state indicators are Green Power beats no more, time has reached a capacity of 100 per cent, it is appropriate withdrawal the AC power plug to prevent the battery charging higher damage the battery. A1045 PowerBook G4 15 battery

 

If the machine is idle load, blocking or side with the state of charge time, then when the load to 3 ~ 4 hours after the state indicators are Green Power beats no more, the battery automatically exit the charge state.

 

Charging process to make a fast loading, when the yellow light power status indicator light (Chang-liang), filled to a certain a certain value in the trickle charge current is slow, when the light condition of power blinks green, the color becomes, was filled with 100%, after it turns green (Chang-liang) of. Charging process of lithium is the constant pressure approach, and began charging voltage which will soon stabilize, while the current becomes smaller and smaller.

 

3. Power is not fully discharged before (eg electricity at 5 ~ 100%), to recharge the battery, otherwise they will reduce the load to increase with the number of cycles of charge cycles and shorten the battery life.

 

When power is 5 ~ 95% battery must be used, so the use of AC Power Adapter will charge the battery (charging state side by side). Satellite A80 battery Satellite M100 battery

 

4. When the power is 96 ~ 100% and the battery removed from the machine can use the AC adapter on, use the AC Power Adapter AC when you please put the DC output plug on the plug into the machine, then plug AC power plug on 220V ~ socket; deleted when the adapter should be first, then unplug the power cord from the machine, unplug the AC adapter DC output device. Otherwise, they could damage your equipment.

 

Using the AC power adapter when the AC power socket to plug it into 220V ~ socket, while the indicator for power status on the machine yet, gave the first (Note : During this period of approximately 5 seconds long), please press the power button to turn, stop or enter sleep, in addition to the fires of green power status indicators have been extinguished all other things, make timely 220V ~ unplugging the power outlet socket (not later than 5 seconds), AC power plug pulled out after about 5 seconds, Green Power status indicator light turns off, otherwise the battery will overcharge and damage the battery. Blocked state due to power adapter is still non-discharge state, the procedures for system power management and chip power management for battery inside the interface circuit composed of 5 seconds some will be automatically transferred to the “off state of charge, and charge the batteries. (If necessary, may, from time to unplug the machine output plug of the AC Power Adapter DC, this time, the battery is discharged through the AC adapter around.) FRU 92P1141 40Y6799

 

If the suspension of work to wait for the machine to enter, or suspend state, no 220V ~ socket disconnect the power cord so when the machines still have the power to maintain. (Not recommended for some time to make the machine enters a wait or suspend the state to take care of your machine.)

 

5. IBM indicators of ThinkPad notebooks information technology have emphasized the “battery” are the manufacturers are measured under conditions specific to the indicator used in our normal phones can not be achieved under the conditions of, for example: information technology-related indicators have shown the “battery” for 4 hours, we can not get the normal of about 3.5 hours of battery power. If the difference is very far and is still under warranty, contact IBM frisky.

 

Maintenance and storage

 

1. If the battery is a long time (several months) are not, we should start the machine remove the saved backup. Recommended that every once and a half or two times the discharge of the battery and the charge order to improve the condition of your battery to increase battery capacity. hp Pavilion dv8000 battery  hp Pavilion dv4 battery

 

2. If the battery is not a long time, it should be set at 30 ~ 50% in equities, it is recommended to charge the battery about once a year, and its capacity is 30 ~ 50%, to prevent excessive discharge and damage to the battery. The battery is 30 ~ 50% of the specific method of operation: When the battery is above 50%, we can turn the power at 30 ~ 50%. If the power consumption of less than 30% when the power first start at 3%, then recharge to 100% and then turn 30 ~ 50% energy can be.

 

3. Do not put the battery temperature and a cold environment, the battery performance is temporarily reduced. Must be in standby mode to save battery power and storage of the State placed in places of lower temperature for the battery, the best temperature range is about 10 ~ 20 degrees Celsius.

 

Load start value is set, the system tray, click the plug (when you start using AC), or a large battery icon white (when you use the battery during startup) / select Improve Battery Health / edit pricing below when the Start value. TravelMate 290 battery BATBL50L6

 

Do not prolong the charge cycle deliberately use substantially changed the management programs charging battery, a starting value, because when you load a low start value set (eg 80%), but with the battery using the AC adapter “charge with the” cycle may take up to three or four months, but if the battery when its use is required to have to deal with their re-activate, otherwise the state of the battery capacity of the poor. It’s actually increased the number of charge cycles and shorten battery life. In addition, the battery every month and a half or so in need of a landfill and order load, which is due to receive a low starting value (eg 80%) after extended charging cycles will be more obvious with the direction.

 

After the battery is fully charged, because the phenomenon of self-discharge capacity fell to 96% usually last about 50 days, while the battery every month and a half or so just need a landfill and load order, it is clear to us from IBM pre-charge starting value of 96% is not unreasonable. However, with aging batteries, the battery is fully charged after the phenomenon of self-discharge of electricity due to fall to 96% of the time may be shortened, this time we need to pay a little more low starting value, so the only time in a month and a half about. A1021 M7332

 

If you often need to live in the office and equipment, between the “two cities” campaign to curb the office with the power adapter supply, while the unit cell site operation, it is recommended that you charge a starting value is set at 6%; This will reduce the load to avoid increasing the number of charge cycles with shortened life cycles of the battery, and will not affect the care of the battery when the laptop movable point.

 

Please note that the issues addressed in the text is limited to IBM ThinkPad notebooks, other brands of machines this article for reference only, since the machines of different brand, its system of power management and control procedures and management of the battery of the battery monitoring programs are not the same rules. GD761 KD476